Getting Started: Vacuum Mode - Shark VAC-THEN-STEAM MV2010WM Owner's Manual

Getting Started: Vacuum and Steam Panel
Your complete bare-floor cleaning and
sanitizing system with Shark® steam
technology has two operating modes:
VACUUM MODE:
1
2
3
OPERATING IN VACUUM MODE:
1 Remove Steam pad and frame,
if attached. See page 8 for
instructions. Vacuum will not activate
if steam frame is attached.
2 SLIDE THE TOGGLE SWITCH UP to
expose the Vacuum Power button.
3 Press the VACUUM POWER BUTTON
to the on position to activate
the vacuum.
4 TOLL FREE: 1-800-798-7398
STEAM MODE:
1
2
3
OPERATING IN STEAM MODE:
1 Attach Steam Pad and Frame.
Steam mode will not work if the pad
and frame are NOT attached. See
page 8 for assembly instructions.
2 Fill the that water tank.
SLIDE THE TOGGLE SWITCH DOWN
to expose the Steam Power button
3 Press the STEAM POWER BUTTON
to turn to the ON position. The
button will be illuminated red when
steam mode is activated.
4
Wait 30 seconds to heat water to
the 212° sanitizing temperature,
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.

Getting Started: Vacuum Mode

After inserting the Telescopic Handle,
your cleaning system is vacuum-ready.
You can begin vacuuming your hard-
surface floors by tilting the cleaning unit
back and pressing the Vacuum Power
button.
1
2
USING VACUUM MODE
1 Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug in the unit.
2
To vacuum, slide the toggle switch
until the Vacuum Power button is
exposed. Press the Vacuum Power
Mode button to the ON position.
IMPORTANT: You can not use the
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
NOTE: Vacuum only sealed and non-
carpeted bare floor surfaces. Refer
to floor manufacturer guidelines and
warnings.
3
3 Place your foot lightly on the top
of the cleaning unit base. Tilt the
cleaning unit back. Vacuum your
floors
IMPORTANT: Vacuum all surfaces
first and then steam-clean to protect
the life and performance of your
product. Avoid vacuuming after
steam mopping.
NOTE: If you vacuum and then
steam-clean one room before
moving on to the next, you will
have to wait 10 minutes for the
condensation to clear before
vacuuming again.
www.sharkclean.com
English
5