Subscribe to Our Youtube Channel
Related Manuals for Shark VAC-THEN-STEAM MV2010WM2
Summary of Contents for Shark VAC-THEN-STEAM MV2010WM2
- Page 1 www.SharkVacThenSteam.com VAC-THEN-STEAM™ MV2010WM2 OWNER’S GUIDE MV2010WM2_11_IB_ENG_110103.indd 1 11-01-03 1:28 PM...
- Page 2 IMPORTANT SAFETY INSTRUCTIONS For Household Use Only 8. To protect against a risk of electric shock, WHEN USING YOUR SHARK VAC- ® DO NOT immerse the appliance into THEN-STEAM™, BASIC SAFETY water or any other liquids. PRECAUTIONS SHOULD ALWAYS 9. DO NOT handle plug or appliance...
- Page 3 19. Carefully remove the micro-fiber pad 35. DO NOT pick up hard or sharp objects immediately after you have unplugged such as glass, nails, screws or coins that and allowed the appliance to cool. could damage the cleaning unit. 36. DO NOT place appliance on unstable 20.
- Page 4 Only this method creates and delivers 212°F steam that is effective enough to clean and sanitize all your hard floor surfaces. The Shark ® Vac-Then-Steam™ can help you achieve a truly clean and healthy environment for you and your family.
-
Page 5: Table Of Contents
English Contents Getting Started: Assembly ..........2 Getting Started: Mode Controls ........4 Vacuum Mode .................5 Steam Mode ................8 Maintaining Your Vac-Then-Steam™ ......12 Troubleshooting Guide ............14 Warranty and Registration ..........15 Visit SharkVacThenSteam.com for more helpful hints and support. www.SharkVacThenSteam.com MV2010WM2_11_IB_ENG_110103.indd 1 11-01-03 1:28 PM... -
Page 6: Getting Started: Assembly
Getting Started: Assembly When assembling your Vac-Then-Steam™ there may be a little water in or around the water tank. This is because we quality test all our Shark products before distributing them, so you get a quality Shark Vac-Then-Steam™. ®... - Page 7 English ASSEMBLY Wrap cord around cord holders and Slide the Telescopic Handle into the secure plug to cord. cleaning unit until it locks into place. NOTE: The Vac-Then-Steam™, is a Once in position, you never have to complete bare-floor cleaning and remove the handle.
-
Page 8: Getting Started: Mode Controls
Getting Started: Vacuum and Steam Panel STEAM MODE: The Vac-Then-Steam™ has two operating modes: VACUUM MODE: DO NOT USE STEAM PAD AND FRAME IN VACUUM MODE OPERATING IN STEAM MODE: Attach steam pad and frame. Steam mode will not work if the pad and frame are NOT attached. -
Page 9: Vacuum Mode
English Vacuum Mode After inserting the telescopic handle, your cleaning system is vacuum-ready. Begin vacuuming your hard-surface floors by tilting the cleaning unit back and pressing the vacuum power button. USING VACUUM MODE Place your foot lightly on the top Pull and twist the quick release cord of the cleaning unit base. - Page 10 Vacuum Mode STORAGE IMPORTANT: Place your foot lightly on the top of Always carry the base. Tilt cleaning unit into the the Vac-Then- upright position. Steam™ by the cleaning unit Turn OFF “O” the vacuum power collar; rather button and unplug the unit. than by the Wrap cord around cord holders and handle.
- Page 11 English EMPTYING THE DUST CUP EMPTYING THE CONE FILTER EMPTYING THE DUST CUP Tap filter canister gently over trash Press the dust cup latch at the receptacle to empty debris from the bottom of the canister upward. Pull conical filter. the dust cup assembly out and down.
-
Page 12: Steam Mode
Steam Mode MAGNETIC CONNECTIONS ASSEMBLY Place the cleaning unit onto the Attach a steam pad onto the bottom Steam Frame. THE UNIT MUST BE of the steam frame, matching the UPRIGHT. hook and loop fasteners. IMPORTANT: steam frame and pad Place the steam frame/pad assembly must be attached to the cleaning unit on the floor with the magnetic... - Page 13 English Do not use chemicals or detergents in your Vac-Then-Steam™. You only need water to achieve super-heated, sanitizing steam. FILLING THE WATER TANK NOTE: If you live in a hard water Keep the cleaning unit in the upright area, we recommend using distilled water in your Vac-Then-Steam™.
- Page 14 Steam Mode STEAM CLEANING Place your foot lightly on the top of Plug in the cleaning unit. Slide the base. TILT HANDLE BACK TO the toggle switch to expose the ACTIVATE STEAM PUMP. steam power button. Push handle upright to stop steam. Press the steam power button to the NOTE: Check water level and fill ON “I”...
- Page 15 English STORAGE CARE OF YOUR MICRO-FIBER Unplug and turn the unit OFF “O”. CLEANING PAD Press your foot on the steam frame. Wash pads in warm water. Wash Separate steam pad from steam separately from other laundry. Only frame. use liquid detergent (no powder detergent).
-
Page 16: Maintaining Your Vac-Then-Steam
Maintaining Your Vac-Then-Steam™ Replacement filter sets have been provided with your product. Use one of the replacement filter sets when another set is drying. Thin Filter Thick Filter CARE OF YOUR DUST CUP FILTERS RECOMMENDED MAINTENANCE Unplug and turn OFF the vacuum. SCHEDULE: Using only water, thoroughly rinse filters every 3 Pull out the dust cup. - Page 17 Use the replacement filter while the other is drying. POST-MOTOR FILTER NOTE: Using only water, thoroughly Twist the Shark logo knob on the rinse filter every 3 months and dry ® post-motor cover counter-clockwise for 24 hours. Replace filter in the to release cover.
-
Page 18: Troubleshooting Guide
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS Your Vac-Then-Steam™ should be securely plugged into a 120V AC electrical outlet only. The Vac-Then-Steam™ Check your fuse or breaker. will not turn on. Switch Steam or Vacuum Power button to the ON “I” position. Make sure the water tank is filled to the indicated fill line. -
Page 19: Warranty And Registration
English ONE (1) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid. - Page 20 Euro-Pro Operating LLC Newton, MA 02459 CAN: Ville St-Laurent, QC H4S 1A7 1-800-798-7398 www.SharkVacThenSteam.com Copyright © 2011 Euro-Pro Operating LLC Printed in China Illustrations may differ from actual product. MV2010WM2.E.110103 MV2010WM2_11_IB_ENG_110103.indd 16 11-01-03 1:28 PM...
Need help?
Do you have a question about the VAC-THEN-STEAM MV2010WM2 and is the answer not in the manual?
Questions and answers