General Settings; Maximum Pin Number 1~6; Number Of Lines In Screen; Transaction Screen Pause - Axxess AX200 Installation & User Manual

www.axxessid.com
Installation & User Guide

General Settings

Maximum PIN Number 1~6

This option sets the maximum number of digits required when using a PIN code. If a PIN only is
being used and the PIN code is less than the number of digits set under this setting, the # key is
required to complete the action.

Number of Lines in Screen

This is the number of transactions kept in active memory, allowing the user to see them instantly
on the main screen. A larger number will use more memory and can affect the speed of the
software.

Transaction Screen Pause

When the main screen is full with transactions, yellow buttons appear allowing you to temporarily
stop incoming transactions. Transactions will still be stored on the hard disk for viewing at a later
stage through the report module. After the set time, the system will automatically resume. The
default setting is 5 minutes.

COM Port Timeout

This is one of the special functions which is hidden until the Special Functions are enabled in the
software. If a device which is communicating trough the COM port doesn't get a respond in a
certain amount of time, the communication will stop. The recommended time is 150 milliseconds.

COM Port Retry Times

This is the number of times that the software will try to reconnect to the device after the COM port
timeout. The default value is 0.
7 6
AX200 Installation & User Guide – July 2007