Axxess AX200 Installation & User Manual page 112

www.axxessid.com
Installation & User Guide
To reset the electronic fuse , disconnect
Lock Relay the power, wait 30 seconds and then
Gâche
reconnect the power.
Electrique zéro le fusible électronique, débranchez
la puissance, attendez 30 secondes et
puis rebranchez la puissance.
Reader wiring connections shown are for
3 2 5
standard AX readers.
W a y F D 9
de câblage de lecteur montrés sont pour
les lecteurs standard AX .
J2
J2
J3 Clock(D1)
J3 Data (D0)
J6
J6
J7 Clock(D1)
J7 Data (D0)
Configuring Verid+
Verid+ has been designed to support PIN entry from a variety of devices – track 2 card readers,
proximity readers, and keypad with Wiegand or track 2 outputs water mark and Wiegand readers.
All new Verid+ units are delivered to accept input from Wiegand input device .Verid+ will need to
be configured to expect the appropriate PIN input device. The appropriate data format for the
finger print reader in order to be compatible with the AX200 system is Wiegand 2601. Therefore
the reader connected to Verid+ unit needs to be programmed to have Wiegand 2601 output. To
do this you need to present the appropriate configuration card within 10 seconds of reader start-
AX200 Installation & User Guide – July 2007
Connection Diagram
AX100 to Verid+
Power
Supply
+12VDC
+ -
Pour remettre à
+12v
0v
Red
Clock (D1)
Green
White
Blue +
Yellow
Black
Reader /
Lecteur
0v
Les raccordements
0V Power Input
12V Power Input
Door Controller
Door Controller
0V PIN Power Output
12V PIN Power Output
PIN Device
PIN Device
1 1 2
J2 J3
Power Input Door Controller
0v
12v
Data (D0)
J6
J7
Power Output
12v
Clock (D1)
Data (D0)
Power Supply Input: 0V
Power Supply Input: 12V
Output to door controller Clock or Wiegand 1
Output to door controller Data or Wiegand 0
Output to external device 0V
Output to external device 12V
Input from PIN-Clock or Wiegand 1
Input from PIN-Data or Wiegand 0