Supermicro SuperServer SSG-540P-E1CTR36L User Manual page 48

Removing a Hot-Swap Drive Carrier from the Chassis
1. Press the release button on the drive carrier, which will extend the drive carrier handle.
2. Use the drive carrier handle to pull the drive out of the chassis.
Installing a Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier, by removing
the screws securing the dummy drive to the carrier. These screws are not used to
mount the actual drive.
Figure 3-7. Removing the Dummy Drive from a Carrier
2. Insert a drive into the carrier with the connector end toward the rear of the carrier. Align
the drive in the carrier so that the screw holes line up. Note that there are holes in the
carrier marked "SATA" to aid in correct installation.
Chapter 3: Maintenance and Component Installation
2
1
Figure 3-6. Removing a Drive Carrier
48
Dummy Drive
Hard Drive
Carrier