Renaming A File; Deleting A File - Casio WK-3200 User Manual

Saving Data

Renaming a File

You can use the procedures in this section to change the name
of a file that you previously saved to external storage media.
PREPARATION
• SmartMedia Card
• Insert the SmartMedia card that contains the file you
want to rename into the keyboard's card slot. Make
sure that the sticker is removed from the card's write
area, which enables writing.
• Floppy Diskette (WK-3700 Only)
• Insert the floppy diskette that contains the file you want
to rename into the keyboard's floppy disk drive. Make
sure that the diskette's write protect hole is closed,
which enables writing.
To rename a file saved to external storage media
1
What you should do first depends on the type of
external storage media you are using.
• SmartMedia Card
On the WK-3700 press the DISK/CARD button twice.
On the WK-3200, press the CARD button once.
• This causes a pointer to appear next to the DISK/
CARD or CARD on the display, and also displays
"Card" in the display's text area.
• Floppy Diskette (WK-3700 Only)
Press the DISK/CARD button.
• This causes a pointer to appear next to the DISK/
CARD on the display, and also displays "Disk" in
the display's text area.
NOTE
• After pressing the DISK/CARD button (WK-3200: CARD
button) once, you can use the [ ] and [ ] CURSOR
buttons to select the external storage media.
2
Press the [ ] CURSOR button to display the Card
Mode (or Disk Mode) menu.
3
Use the [ ] and [ ] CURSOR buttons to display
the "Rename" screen.
4
Press the [ ] CURSOR button to advance to the
file type selection screen.
5
Use the [ ] and [ ] CURSOR buttons to select the
type of the file you want to rename.
E-90
6
Press the [ ] CURSOR button to display the file
name selection screen.
7
Use the [ ] and [ ] CURSOR buttons or [+] and
[–] buttons to select the name of the file you want
to rename.
• You could also use the number buttons to input a
three-digit file number. The file number is shown in
the number area of the display.
8
Press the [ ] CURSOR button to advance to the
file name input screen.
• Use the [+] and [–] buttons to scroll through letters at
the current cursor location. See the page E-92 for
information about inputting text.
• Use the [ ] and [ ] CURSOR buttons to move the
cursor left and right.
9
After inputting the file name, press the [ ] CURSOR
button.
• This will display a confirmation message asking
whether you really want to change the name.
0
Press the YES button to change the file name.
• This will cause the message "Pls Wait" to appear on
the display to indicate that a card access operation is
being performed. Never try to perform any other
operation on the keyboard while the card is being
accessed. The message "Complete" will appear on the
display after renaming is complete. After a few
seconds, the message will be replaced by the file name
selection screen.
• If you do not want to continue with file renaming,
press the EXIT button or the NO button in response
to the above confirmation message. This will return
you to the file selection screen.
A
After you are finished performing the rename
operation, press the DISK/CARD button (CARD
button on the WK-3200) to exit the Card Mode.

Deleting a File

You can perform the procedure in this section to delete a file
from external storage media.
IMPORTANT!
• Note that the file delete operation cannot be undone.
Make sure that you no longer need data before you
delete it.
• Deleting a file causes all of the file numbers following it
to be reduced by one. If you plan to delete another file,
make sure that you do not specify the wrong file number.
738A-E-092A