Schwinn 420 Assembly Manual page 14

Step 7: Install Feet
Parts
• Main Unit (from Step 6)
• #2 - Left Foot (Qty. 1)
• #3 - Right Foot (Qty. 1)
• #14 - Foot Mount Plate (Qty. 1)
Hardware
• #24 - M8 Flat Washer (Qty. 8)
• #25 - M8 Lock Washer (Qty. 8)
• #29 - M8x15 Hex Screw (Qty. 4)
• #32 - Round Cover (Qty. 2)
• #33 - Cotter Pin (Qty. 2)
• #34 - M8x20 Hex Screw - Nylock (Qty. 2)
• #35 - M8x25 Hex Screw - Nylock (Qty. 2)
Tools
• Phillips Head Screwdriver
• Combination Wrench (Qty. 2)
2
14
24
25
29
Assembly
33
34
Do steps 7-1 thru 7-3 on one side and then again
on the other side.
7-1 Move the shaft under the pedal into the pivot on the
Leg Assembly. Align a Foot Mount Plate with the pivot
and the Foot Assembly. Attach with three M8 Locking
Washers, three M8 Flat Washers, two M8x15 Hex
Screws (outside holes), and one M8x20 Hex Screw
(center hole).
7-2 Set the Foot Assembly in the U-bracket at the bottom of
the Lower Handlebar. Put a Cotter Pin from the inside
through the U-bracket and Foot assembly. Attach
with M8x25 Hex Screw, M8 Lock Washer, and M8 Flat
Washer.
NOTE: Make sure the key on the Cotter Pin engages
the slot in the U-bracket.
7-3 Tighten the screws holding the arms and then put a
Round Cover over the head of each screw.
7-4 Fully tighten all hardware in Steps 6 and 7.
32
14
Assembly Manual
24 25
35
3