Schwinn 420 Assembly Manual page 11

Step 4: Install Static Handlebar and Console
Parts
• Main Unit (from Step 3)
• #19 - Console (Qty. 1)
• #20 - Static Handlebar (Qty. 1)
Hardware
• #24 - M8 Flat Washer (Qty. 4)
• #25 - M8 Lock Washer (Qty. 4)
• #30 - M8x20 Hex Screw (Qty. 4)
• Pre-installed Screws in Back of Console (Qty. 4)
Tools
• Phillips Head Screwdriver
19
Assembly
W5
W4
20
4-1 Feed the Heart Rate Wire (W3) from the Static Handlebar
through the rectangular opening in the handlebar.
4-2 Put the Console Mast Wire (W2) through the rectangular
opening in the Static Handlebar. The Heart Rate Wire
goes through the notch (N) in the Console Mast. Connect
the Static Handlebar to the Console Mast with the
hardware shown.
NOTICE: Do not pinch the wires when putting the
4-3 Remove the 4 pre-installed screws (S) in the back of the
Console. Save them for Step 4-5.
4-4 Connect the Console Wire (W4) to the Console Mast
Wire (W2). Connect the Heart Rate Wire to the Heart
Rate connector (W5) from the back of the Console.
4-5 Attach the Console to the Static Handlebar assembly
with the screws from Step 4-3.
NOTICE: Do not pinch the wires when putting the
W3
S
W2
24
25
N
11
Assembly Manual
Static Handlebar on the Console Mast.
Console on the Static Handlebar.
30