Arjo AtmosAir Velaris Quick Reference Manual
Hide thumbs Also See for AtmosAir Velaris:

Advertisement

Quick Links

QUICK REFERENCE GUIDE - CLEANING AND DISINFECTION
AtmosAir Velaris

Disinfectants

DISINFECTANT
Alcohol solution ≤ 70%
Chlorine solution ≤ 1% (10,000 ppm)
Quaternary ammonium solution 1920ppm
Quaternary ammonium solution, 3-15%
Hydrogen peroxide solution, 3-10%.
Chlorine concentrations may vary from 250 ppm to 10,000 ppm depending on local policy and contamination
1
status.
NOTE
Rinse and dry thoroughly with clean water to remove residual chemicals after disinfecting with each
chemical before storage
WARNING
• To avoid eye and skin damage, always use protective glasses and protective gloves. If contact
occurs, rinse with plenty of water. If eyes or skin become irritated, contact a physician.
Always read the material safety data sheet of the disinfectant.
• To avoid electrical shock, always disconnect the pump from the power source before cleaning and
inspecting.
• To prevent cross-contamination, always follow the disinfection instructions in this IFU.
• To avoid eye or skin irritation, never disinfect in the presence of a patient.

Accessories needed for cleaning/ disinfection

• Protective glasses
• Protective gloves
• Spray bottle with cleaning solution
• Spray bottle with disinfectant solution
• Spray bottle with water
• Cloths
HYBRID MATTRESS
SYSTEM
1
08.AAV.02EN_02 • 10/2021 • Page 1/3
BOTTOM
TOP COVER
COVER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AtmosAir Velaris and is the answer not in the manual?

Questions and answers

Summary of Contents for Arjo AtmosAir Velaris

  • Page 1 QUICK REFERENCE GUIDE - CLEANING AND DISINFECTION AtmosAir Velaris Disinfectants HYBRID MATTRESS BOTTOM DISINFECTANT TOP COVER SYSTEM COVER ● ● ● Alcohol solution ≤ 70% ● ● ● Chlorine solution ≤ 1% (10,000 ppm) ● ● ● Quaternary ammonium solution 1920ppm Quaternary ammonium solution, 3-15% ●...
  • Page 2 Clean and disinfect (26 steps) Always follow these steps for proper cleaning and disinfection after each patient. Prepare the pump 1. Disconnect the pump from the mattress. 2. Select Standby on the pump unit. Disconnect the pump from the power source.
  • Page 3 25. After washing, allow the top cover to air dry (preferred) or tumble dry at 40°C (104°F) or up to 80°C (176°F) maximum. 26. Once dry refi t the top cover to the mattress / seat cushion. ArjoHuntleigh AB Hans Michelsensgatan 10 211 20 Malmö, Sweden www.arjo.com 08.AAV.02EN_02 • 10/2021 • Page 3/3...

Table of Contents