General Setup; Sld4 Loop Inductance Link Settings - Siemens SLD4 Application Notes

General Setup

2. General Setup
In most cases, the use of the 'Configuration Tool' is necessary in order to get the optimum
settings of the SLD4 for these application types.
To communicate with the SLD4 then the following items will be required:
5. Laptop PC or LRT Netbook
6. PC based "SLD4 configuration Tool" 667/TZ/45216/000
7. USB cable interface 702/4/08535/000
AC Supplies
When using 24 AC supply to the detector, only use battery powered interface equipment (e.g.
laptop, PDA). Do not connect mains powered/connected interface equipment to the SLD4. Fail-
ure to observe these precautions may damage the detector and/or the connected device
2.1.

SLD4 Loop Inductance Link Settings

The links for loop sensitivity are shown below (PL3, PL4, PL5, PL6):-
LK1
Figure 1: Links for sensitivity (two per loop)
Loop Detector Application Notes SLD4
667/HQ/45200/101
PRESENCE MODE/FREQ
LK5
IR Downlink
LK4
1
PL3
1
PL4
1
PL5
1
PL6
IR Uplink
9