Table of Contents
Advertisement
Table A18 - Setting response to Wind ON command
01. Press and hold the programming pushbutton (fig. 1).
02. Release the programming pushbutton (fig. 1) when the LED illuminates with green color (4th position).
04. Press key of the transmitter to select response to Wind ON command:
•
t (or third channel) – go to Down position
•
s (or first channel) – go to Up postion (default)
05. Currently set response to Wind ON command will be confirmed with LED flashes:
•
LED emits 2 green flashes - go to Down position
•
LED emits 4 green flashes - go to Up position
06. After 10 seconds, if the device doesn't receive any signal, the programming procedure concludes auto-
matically
5.7 - Deleting transmitters
If memorised transmitters and settings need to be deleted, proceed as described below.
Table A19 - Deleting transmitter from memory
01. Press and hold the programming pushbutton (fig. 1).
02. Release the programming pushbutton (fig. 1) when the LED illuminates with yellow color (8th position).
03. Press any key on the acquired transmitter to remove it from memory.
04. LED emits 3 yellow flashes to confirm the correct removal.
05. After 10 seconds that the device doesn't receive any signal, the programming procedure concludes auto-
matically.
5.8 - Factory reset
If the control unit needs to be reset to the factory settings (all transmitters and setting will be deleted), proceed as described below.
Table A20 - Restoring to factory defaults
01. Press and hold the programming pushbutton (fig. 1).
02. Release the programming pushbutton (fig. 1) when the LED illuminates with yellow color (8th position).
03. Press the programming pushbutton (fig. 1).
04. LED emits 5 yellow flashes to confirm the correct reset.
05. The programming procedure concludes automatically.
Afterwards the control unit will initiate the start-up procedure according to table A2.
6
LED SIGNALS
6.1 - Programming menu
When pressing and holding the programming pushbutton on the control unit, the LED will signal consecutive positions of the programming menu.
Table A21 - menu positions when holding the programming pushbutton
Nº
Color
1
Red
2
Orange
3
Blue
4
Green
5
White
6
Violet
7
Cyan
8
Yellow
Description
Memorization in Mode I
Memorization in Mode II
Calibration
Response to Wind ON command (see Table A18)
Partial position settings
Stopping with pushbuttons settings
Venetian blinds mode settings
Reset
Example
/
2/4
Example
Example
Advertisement
Table of Contents
