Deleting Transmitters - Nice BiDi-Dimmer Instructions And Warnings For Installation And Use

5.3 - Type of connected switches
The control unit allows to connect momentary or toggle switches to S1 and S2 input. By default, the toggle switch type is set.
To change type of connected switch, proceed as described below.
Table A13 - Setting type of connected switches
01. Press and hold the programming pushbutton.
02. Release the programming pushbutton when the LED illuminates with violet color (5th position).
03. Press key of the transmitter responsible for turning ON to toggle the setting, the LED informs about current
setting:
• Fixed white – momentary switch
• Flashing white – toggle switch
04. After 10 seconds that the device doesn't receive any signal, the programming procedure concludes auto-
matically.
5.4 - Favourite brightness level
The control unit enables setting a quickly accessible favourite brightness level. Favourite level works only with transmitters memorized in Mode
I. To recall the favourite brightness level: press s and t or 1st and 3rd channel at the same time. In order for this function to work, the
load must be calibrated. By default, the favourite brightness level is set to 50%.
To set new favourite brightness level, proceed as described below.
Table A14 - Setting partial position
01. Press and hold the programming pushbutton.
02. Release the programming pushbutton when the LED illuminates with white color (6th position).
03. Bring the light at your desired brightness level
04. Save and conclude the programming by pushing the programming pushbutton.

5.5 - Deleting transmitters

If memorised transmitters and settings need to be deleted, proceed as described below.
Table A15 - Deleting transmitter from memory
01. Press and hold the programming pushbutton.
02. Release the programming pushbutton when the LED illuminates with yellow color (7th position).
03. Press any button on the acquired transmitter to remove it from memory.
04. LED emits 3 yellow flashes to confirm the correct removal.
05. After 10 seconds that the device doesn't receive any signal, the programming procedure concludes auto-
matically.
5.6 - Factory reset
If the control unit needs to be reset to the factory settings (all transmitters and settings will be deleted), proceed as described below.
Table A16 - Restoring to factory defaults
01. Press and hold the programming pushbutton.
02. Release the programming pushbutton when the LED illuminates with yellow color (7th position).
03. Press the programming pushbutton.
04. LED emits 5 yellow flashes to confirm the correct reset.
05. The programming procedure concludes automatically.
Afterwards the control unit will initiate the start-up procedure according to table A4.
Example
> /
Example
Example
Example