MakingFoam - Panasonic ES-ST37 Operating Instructions Manual

After charging is
While charging
completed
The charge status The charge status
lamp ( ) glows lamp (
red.
• After charging is completed, turning the power switch ON with
the shaver plugged in will cause charge status lamp (
up and then turn off after 5 seconds.
This shows that the shaver is fully charged.
• Recommended ambient temperature for charging is 10 – 35 °C.
It may take longer to charge or the battery may fail to charge
properly in extremely high or low temperatures.
The charge status lamp ( ) will blink twice every second when
there is a problem with charging.
Charge the shaver within the recommended ambient temperature
range.
• When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp (
may not glow. It will eventually glow if kept connected.
4
4
Disconnecttheadaptorafterchargingis
completed.
• Charging the battery for more than 1 hour will not affect
battery performance.
Note
You cannot operate the shaver while charging.
10
Abnormal
charging
The charge status
lamp ( ) will blink
) turns
twice every
off.
second.
) to light

Makingfoam

It is easier to make foam this way than by hand.
• After using the shaver in shaving foam mode, always rinse the
main body with water and apply oil to the blades. (See page 13.)
► Usablefacialcleansers,etc. 
Shaving foam
Shaving agent Shaving gel
Shaving cream
Facial cleansing foam
(without scrubbing compounds)
Facial cleansing foam
Facial cleanser
(with scrubbing compounds)
Facial soap
Liquid
Body soap etc.
Foam
1
1
Takeanappropriateamountof
facialcleanseretc.inthepalmof
yourhand.
)
2
2
Addanappropriateamountof
waterorhotwater.