CleaningTheShaver - Panasonic ES-ST37 Operating Instructions Manual

2
2
Holdtheshaverasillustrated
andshave.
• Start shaving by applying gentle
pressure to your face. Stretch your
skin with your free hand and move the
shaver back and forth in the direction
of your beard. You may gently increase
the amount of pressure as your skin
becomes accustomed to this shaver.
Applying excessive pressure does not
provide a closer shave.
You can also use a pen grip to hold the
shaver.
► Usingthetrimmer

Slide the trimmer handle up. Place at a
right angle to your skin and move
downwards to trim your sideburns.
► Notes

• Before shaving, check that the cleaning shutter is closed.
• Place your finger on the finger rest while in use. Keeping your
finger placed on the power switch during use may switch the
mode or turn the shaver OFF.
• Do not use shaving creams or face cleansers containing
scrubbing compounds as these may cause the outer foil to clog.
• The appliance may not operate in an ambient temperature
approximately 5 °C or lower.
12
Readinglampswhenusing
When the battery capacity is low
The charge status lamp ( ) blinks once every
second when operating the shaver.
• You can shave 2 to 3 times after the charge status lamp (
blinks. (This will differ depending on usage.)
• A full charge will supply enough power for approx. 14 shaves of 3
minutes each.
• If the shaver is operated in the shaving sensor mode in a
battery‑shortage condition, the shaving sensor lamp (
blue, and the charge status lamp (

Cleaningtheshaver

1. Remove the shaver from the charging stand.
2. Apply some hand soap and some water to the
outer foil.
• Close the cleaning shutter.
3. Turn the shaver on.
Therearetwowaystocleantheshaver,dependingonthe
actualdirtlevel.
▼
)
) glows
) blinks red.
2
▼
▼