MakingFoam - Panasonic ES‑ST37 Manual

After charging
While charging
is completed
The charge The charge
status lamp ( ) status lamp ( )
glows red.
• After charging is completed, turning the power switch
ON with the shaver plugged in will cause charge status
lamp ( ) to light up and then turn off after 5 seconds.
This shows that the shaver is fully charged.
• Recommended ambient temperature for charging is
10 – 35 °C. It may take longer to charge or the battery
may fail to charge properly in extremely high or low
temperatures.
The charge status lamp ( ) will blink twice every
second when there is a problem with charging.
Charge the shaver within the recommended ambient
temperature range.
• When charging the shaver for the first time or when it
has not been in use for more than 6 months, the
charge status lamp ( ) may not glow. It will eventually
glow if kept connected.
4
4
Disconnect the adaptor after charging is completed.
• Charging the battery for more than 1 hour will not
affect battery performance.
Note
You cannot operate the shaver while charging.
ES-ST37_CH.indb 29
Abnormal
charging
The charge
status lamp ( )
will blink twice
turns off.
every second.
Making foam
It is easier to make foam this way than by hand.
• After using the shaver in shaving foam mode, always
rinse the main body with water and apply oil to the
blades. (See page 33.)
►Usable facial cleansers, etc.
Shaving foam
Shaving gel
Shaving agent
Shaving cream
Facial cleansing foam
(without scrubbing
compounds)
Facial cleanser
Facial cleansing foam
(with scrubbing compounds)
Facial soap
Liquid
Body soap etc.
Foam
1
1
Take an appropriate amount of
facial cleanser etc. in the palm of
your hand.
–
–
29
2014/11/20 9:40:11