Final brainLight UX3000 User Manual page 23

Performing Factory Reset ----------------- -
If the headphone Is havlng dlfflculty palrlng to a devlce, please follow the simple steps below to
perform a factory reset.
1. While the headphone power is ON, press and hold the Volume + Button and the Volume -
Button simultenously for 2 seconds and the Bluetooth/ANC Status lndicator will flash twice in
Purple together with 2 beeps.
2. The factory reset is completed. The headphones will start device pairing mode automatically
wlth the Bluetooth/ANC Status lndlcator flashes alternately ln Red and Blue.
•11 the problem Is not resolved even alter performlng the factory reset, please try the method below:
1. Plug the 3.5mm Analog Audio Cable lnto the 3.5mm Audio Jack of the headphones. This wlll
automalically turn off the power of the headphones.
2. Unplug the cable and power ON the headphones. The problem should be resolved.
Connecting the Headphones to a Device Using the Analog Audio Cable --
The headphones can be used with any device through physical wired connection by connecting
the headphones' 3.5mm Audio Jack to the devlce wlth the supplled analog audio cable. Once the
3.5mm Audio Jack is plugged in, the headphones will turn OFF immediately with all media contrais
being disablod. Please perform media contrais via tho connocted device instead.
• Il is possible to activate the ANC fuction when the headphone is used with physical wired
connection.
• As the headphone power is OFF, no announcement of "Noise Cancelling" or "OFF" will be made
when the ANC functlon ls actlvated or deactlvated. Please refer to the Bluetooth/ANC Status
lndicator for the status of ANC function.
23