Advertisement
Available languages
Available languages
Troubleshooling: When you lhink, "1s il broken?" ----------
Problem
Headphones wlll
not turn OFF
ln case it takes
lime to charge
Cause
An errer has occurred
due to lmproper
operalion
Power Butten has not
been pressed for
adequate lime
ANC function has not
been deactivated
The output of the USB
adapter being used
for charging is low
Headphone power automatically turns OFF once
the analog audio cable is connected. Please try
to connect the cable and check if the Bluetooth/
ANC lndlcator Is completely turned OFF or
turned into Green. Then please disconnect the
cable and check again if the power can be
tumed ON/OFF. If the problem Is not solved,
please perform the factory reset by referring to
"Performing Factory Reset" on P. 23
Please press and hold the Power Butten long
enough for the headphones to tum OFF.
Please refer to "Powerlng OFF" on P. 20 for
the details of the method.
Please make sure that the ANC function is
properly turned OFF slnce the ANC functlon can
be activated even when the power is OFF. After
using the headphones, please turn OFF the ANC
function on top of powering OFF. Please rel or to
"Deactlvatlng ANC Functlon' on P. 21 for the
details of the method.
ln case you are using the USB port on a PC,
etc .. there are cases in which the output is low
and it may take more time to charge than the
time stated on the specification. As such please
use a 5V/1A USB adapter for charglng thls product.
27
Remedy
Advertisement
