Sr Originalno Uputstvo Za Upotrebu - Hilti SF 6-A22 Original Operating Instructions

Trouble or fault
The control switch cannot be
pressed, or is stuck.
The drill / driver or the battery
gets very hot.
9 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances:
• SF 6-A22: qr.hilti.com/r9370541
• SF 6H-A22: qr.hilti.com/r9370482
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Originalno uputstvo za upotrebu
1 Podaci o dokumentaciji
1.1 O ovoj dokumentaciji
• Pročitajte ovu dokumentaciju pre početka rada. To predstavlja preduslov za bezbedan rad i nesmetano
rukovanje.
• Obratite pažnju na bezbednosne i upozoravajuće napomene koje se nalaze u ovoj dokumentaciji i na
proizvodu.
• Uputstvo za rukovanje uvek čuvajte na proizvodu i samo ga sa ovim uputstvom prosleđujte dalje drugim
osobama.
1.2 Legenda
1.2.1 Upozoravajuće napomene
Upozoravajuće napomene upozoravaju na opasnosti pri rukovanju proizvodom. Koriste se sledeće signalne
reči:
12 Srpski
Possible cause
The forward/reverse selector
switch is in the middle position
(transport position).
Electrical fault
The drill / driver is overloaded (ap-
plication limit exceeded).
Action to be taken
▶ Set the forward/reverse selector
switch to forward or reverse ro-
tation, as applicable. → page 9
▶ Switch the drill / driver off
immediately, remove the battery
and contact Hilti Service.
▶ Check the application.
2231428
*2231428*