LawnMaster GT1454 Operator's Manual page 10

ASSEMBLY
WARNING
Before assembly, make sure that the grass trimmer is switched off and
unplugged.
FITTING THE GUARD
1. Fit the debris guard into the slots on the trimmer housing and align the screw holes in the debris
guard with those in the trimmer head. Place the guard in position (Fig. 1).
2. Secure the guard with the screws using a phillips screwdriver (Fig. 2).
Fig. 1 Fig. 2
FITTING THE FLOWER GUARD
1. Pull the flower guard wide enough to extend wide enough to fit over the motor housing (Fig. 3).
2. Insert both ends of the steel bar into the recessed cavities on the motor housing (Fig. 4).
Fig. 3 Fig. 4
WARNING
Never use the grass trimmer unless the guard is properly fitted.
10