Table of Contents
Advertisement
Chapter 5
5-14
CLI (Command Line Interface)
PSTN Configuration Menu
In the PSTN Configuration Menu, you can set the PSTN interface that is required to connect to
the PSTN trunk line. You can also view the values of parameters.
At the SMG-3200 prompt of the main screen, type 'pstnmenu' and press [Enter]. The following
PSTN Configuration Menu screen will be displayed.
<<<<< PSTN Configuration Menu >>>>>
[0] Gateway Operation Mode
[1] PSTN Rerouting Insert Digit
[2] PCM Method
[3] Dial Method
[4] SLC Signal
[5] Trunk Signal
[6] Call Control Method
[7] Ring Cadence
[8] System Tone Cadence
[9] CO Tone Cadence
[10] Gain Control
[11] Diagnosis
[12] MMC Port Block/UnBlock
[13] Display Slot Configuration
[14] Display Port Status
[15] Save & Exit
[16] Exit
Select ?
Advertisement
Table of Contents
