Kenmore 795.71312.311 Service Manual page 55

https://appliancetechmanuals.com
12-2-4 Test Icemaker Mode
Test function starts when test switch is pressed for more than 3 seconds. User shouldn't force operation while doing test
mode, service or cleaning.
Test switch will work only when ice tray its in horizontal position, not during ice ejection or water supplying.
When pressing the Test Switch, feeler arm will sense and then ice tray will start ice ejection, after twisting, ice tray
returns to initial position. When returning to horizontal position, water supply will start filling the ice tray. After this, test mode
its done.
Test mode cycle elapsed time of 30 seconds its shown as the next sequence:
Feeler arm sensing – Ice ejecting – Ice tray returns to horizontal position – Water supply.
12-2-5 Water Supply Function
This function is for supply water to tray, by the mechanic water valve, when ice ejecting finish and tray return to initial position.
Water supply quantity depend of DIP S/W.
Water Supply Time Table
No
1
2
3
4
If water supply setting is changed while system is energized, change will be made immediately. But if change occurs when
water supply function is working, change will be executed next cycle of icemaker
12-2-6 Ice maker stop switch
• Ice Maker Stop S/W ON state, Ice Maker normal operation
• Ice Maker Stop S/W OFF state: Ice Maker do not operate
TEST
SWITCH
DISP S/W
Water Supply Time
S1 S2
OFF OFF
ON OFF
OFF ON
ON ON
POWER
SWITCH
9.0
8.0
DIP S/W Setting will be depend of
10.0
11.0
* DIP switch is on the main PCB.
Note
water pressure