Getting Started - tams elektronik mControl 40-01607 Manual

1. Getting started

Contents of the package
After unpacking, check the delivery for completeness:

mControl

connection cable (red) with RJ-45 connectors (at least Cat. 5e)

short-circuit plug (jumper)
Required accessories
As power supply for the mControl and the connected Märklin** additional devices (keyboards,
controls) you need a DC or AC plug-in power supply (e.g. item no. 70-09110-01). Technical
data:

Connection: Hollow plug (2.1 mm)

Output voltage: 12-16 V

Current: at least 1 A
Intended use
The mControl is intended for use in digital model railway layouts according to the
specifications in the instructions. Any other use is not in accordance with the intended use and
will result in the loss of the warranty claim. Intended use also includes reading, understanding
and following all parts of the instructions. The mc² is not intended to be used by children
under the age of 14.
Safety instructions
Improper use and non-observance of the instructions can lead to incalculable hazards. Prevent
these dangers by carrying out the following measures:

Use the mControl unit only in closed, clean and dry rooms. Avoid humidity and splash
water in the environment. After condensation has formed, wait two hours for
acclimatisation before use.

Disconnect the mControl unit from the power supply before carrying out wiring work.

Only plug the mains plug of the power supply unit into properly installed and fused earthed
sockets.

Heating of the device and the power supply unit during operation is normal and harmless.

Do not expose the devices to high ambient temperatures or direct sunlight. Observe the
information on the maximum operating temperature in the technical data.

Regularly check the operational safety of the devices, e.g. for damage to the connection
cables or damage to the housing.

If you notice damage or if malfunctions occur, switch off the supply voltage immediately.
Send in the mControl for inspection.

Dangerous voltages occur inside the power supply unit. Therefore, never open the housing
of the power supply unit.
mControl
3