Update With The Mastercontrol; Update With The Redbox - tams elektronik mControl 40-01607 Manual

mControl

5.2. Update with the MasterControl

Change to the menu item "Software update" on the MasterControl and confirm the selection
with # / ok. → The display of the MasterControl shows "...Download..." in the bottom line.
Now establish the connection to your PC and then start the update programme on the PC.
Please note: Always establish the connection to the PC before starting the programme.
Otherwise, the software may not correctly recognise the interface via which you have
connected your PC to the MasterControl.
Continue according to the instructions of the programme.

5.3. Update with the RedBox

To update with the RedBox, you need the software "CV-Navi", which you can download free
of charge from our homepage.
Please note: Always connect to the PC before starting the CV-Navi programme. Otherwise
the software may not correctly recognise the interface through which you have connected
your PC to the RedBox.
In the "CV-Navi" programme, select the "Update" tab and activate the update mode by
selecting the "Starte EasyNet Geräte Update Modus" button. Then select the file with the
current firmware that you have saved on your PC ("Datei eingeben") and start the update
("Aktualisierung straten".
Note: To end the update mode for the RedBox, you must briefly switch it off.
10