Table of Contents
Advertisement
Place the rim belt in position over the air valve before inserting it into the rim. The
rim belt can now be pulled over easily. Check that all spoke heads are covered (a
rim belt is not required in the case of a plastic rim).
Push the tyre over the edge of the rim, starting behind the air valve. Inflate the tube
slightly until it is round, and place it inside the tyre.
If the tube fits inside the tyre without any folds (in case of folds: let out some air),
then the upper side of the tyre can be pressed lightly onto the rim with both hands,
starting at the air valve. Lightly push the air valve inwards and pull it out again to
make sure that the tyre is positioned properly in the region of the air valve.
Check all around on both sides that the tube is not pinched between the rim and the edge of the
tyre. Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned
properly in the region of the air valve.
To ensure that the wheel inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of
the rim on both sides of the tyre, then the tyre is centred properly. If not - let out the air and position
the tyre afresh.
Now the tyre can be inflated to its full operating pressure (note the maximum!!) and the valve cap
should be replaced.
Installation manual
- 9 -
EN
Gemini 2
2021-06
Contents
NL
Advertisement
Table of Contents
