Issued By: RBC Bioscience Corp.
MagCore HF48 Service Manual
Revised: February,2014
Ver. 2014-2
4. Screw off the 2 screws (2mm hex wrench) on the timing wheel of the Y-axis belt and
move the belt gear up to detach it from the machine.
5. Screw off the 4 screws (3mm hex wrench) on the fixing plate of the Y-axis motor.
6. Install a new Y-axis motor.
7. Attach the belt gear on the Y-axis motor.
8. Plug in the power plug of the Y-axis motor and the connection on the sensor.
9. The replacement of the Y-axis motor is finished.
4
5
RBCBioscience
54