Walk Test; Led Indicator - Optex InSight INS-QXI-ST Installation Instructions Manual

4-4. Walk test

4-5. LED indicator

LED
[1] Warm-up
[2] Alarm
[3] Walk test end
1
Turn LED back ON, if it was turned OFF (
2
Walk around the detection area to make sure it is set as intended.
If necessary, turn LED OFF again.
3
4 Fix the cover with the cover lock screw included in the housing,
after completion as necessary.
Caution
For the walk test, walk at least 1.0 m (3' 3" ) away from the detector.
NOTE
For confirmation, the LED will light up according to the alarm output for 3 minutes
after the detector cover is installed again in any setting.
Conduct a walk test at least once a year.
Seconds
60
2
5
- 9 -
Detection area settings and walk test
DIP switch No. 1
Step
4
, Default ON).