Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Grant-bio MM-1000
Summary of Contents for Grant-bio MM-1000
- Page 1 Overhead Stirrer Multi Mixer MM-1000 Operating Manual...
-
Page 2: Table Of Contents
About this edition of the manual 1.1. The current edition of the operating manual applies to the following models: Model Version MM-1000 Multi Mixer, Overhead Stirrer Multi Mixer V.2AW Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Page 2... -
Page 3: Safety Precautions
The user is responsible to carry out appropriate decontamination if hazardous material spills on or penetrates into the equipment. • The user is responsible for decontamination of the unit before its decommissioning and utiliza- tion. Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Operating Manual Page 3... -
Page 4: General Information
• Vibration MM-1000 performs separate (mono–) (1; 2; 3), consecutive binary cycles (c) (1–2) × c; (1–3) × c and (2–3) × c and complex tri-cycles (1–2–3) × c. Speed, angle and time of stirrer rotation is under microprocessor control. - Page 5 Fix the stirring rod (fig. 1/6) in the clamp (fig. 1/5) without applying excessive transverse axial force. Connect the external power supply to the connector on the back of the appliance. Remove the protective film from the display. Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Operating Manual Page 5...
-
Page 6: Operation
Run Stop key. Pressing the Run Stop key again will start the program from the begin- ning (timer will be restarted). 5.11. After finishing the operation, turn off the power switch. 5.12. Unplug the external power supply from the mains. Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Page 6 Operating Manual... -
Page 7: Program Setting
2/C and 2/D). MM-1000 is programmed to change the direction of rotation when the motion timer is restarted, i.e. if the rotation time is set to 30 s, then the direction is changed every 30 s as shown on figure 3, where positive RPM is clockwise motion and negative - counter clockwise. - Page 8 (1-250 s, fig. 8/D) - this is the duration of pause. Set the turning angle (1-5º, fig. 8/B) and time (1-5 s, fig. 8/E) for vibro motion. Graph in figure 9 shows motion in this mode. Figure 8. Figure 9. Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Page 8 Operating Manual...
-
Page 9: Specifications
Weight, accurate within ±10% ..................2.4 kg 7.13. Ordering information 8.1. Models and versions available: Model Version MM-1000 Multi Mixer, Overhead stirrer, without accessories V.2GW 8.2. To inquire about or order the optional accessories, contact manufacturer or your local manufacturer representative. 8.2.1. Optional accessories:... -
Page 10: Guarantee And Service
After transportation or storage and before connecting it to the electric circuit, keep the unit under room temperature for 2-3 hrs. 10.3. Extended storage of the unit does not require special procedures. Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Page 10 Operating Manual... -
Page 11: Compliance
This product does not contain any Substances of Very High Concern (SVHCs) at greater than 0.1% that have to be identified in accordance with Regulation (EC) No 1907/2006 and therefore does not have an entry in the SCIP database. Edition 2.04 – December of 2021 Overhead Stirrer Multi Mixer MM-1000 Operating Manual Page 11... - Page 12 (Cambridge) Ltd Grant Instruments Europe B.V Shepreth Strawinskylaan 411 Cambridgeshire WTC, Tower A, 4th Floor SG8 6GB 1077 XX Amsterdam The Netherlands Tel: +44 (0) 1763 260811 Email: grant@eu.grantinstruments.com Email: salesdesk@grantinstruments.com www.grantinstruments.com Overhead Stirrer Multi Mixer / MM-1000 / 2.04...
Need help?
Do you have a question about the MM-1000 and is the answer not in the manual?
Questions and answers