Cts; Dcd; Dsr; Dtr - ADTRAN 1200184L1 User Manual

SIGNAL RTS V.54 LOOPBACK

CTS

Follows

DCD

—

DSR

—
— = Do not care
Force On = On under all conditions
61200.184L1-1
CTS
Write security: 3; Read security: 5
Clear to Send. Used to control characteristics of CTS (see Table 3-A).
Choose from Normal or Forced On.
DCD
Write security: 3; Read security: 5
Data Carrier Detect. Indicates to the DTE when a valid signal is being re-
ceived at the Network Interface (see Table 3-A). Choose from Normal or
Forced On.
DSR
Write security: 3; Read security: 5
Data Set Ready. This signal indicates to the DTE when the DCE is turned
On and ready for operation (see Table 3-A). Choose from Normal or
Forced On.

DTR

Write security: 3; Read security: 5
Data Terminal Ready. This parameter determines whether the ATLAS 800
treats a connection as permanent (DTR=Ignore) or to connect only when
DTR is active (DTR=Connect On DTR). Select either Ignore or Connect on
DTR.

0 Inh (Zero Inhibit)

Write security: 3; Read security: 5
When the port detects an uninterrupted string of 0s being transmitted for
more than one second, setting this parameter to ON will cause the ATLAS
800 to send 1s toward the network.
(conditions which cause the port control signal to be deactivated)
511 TEST ON SELF TEST ACTIVE
Off Off
— —
Off Off
Quad Nx 56/64 Module User Manual
NETWORK
TEST ACTIVE
Off Off
Off Off
Off Off
Chapter 3. Operation
Table 3-A
Normal Mode Operation
NO DS0 NETWORK
MAPPED ALARM
Off Off
Off Off
Off —
13