Magnetic Autocontrol MPH 112 Operating Instructions Manual page 97

5817,5005EN / Version 01
4. Take the drive unit off its block. Loosen fixing screw. Refer to
Page 94, Fig. 34. Make sure that the counter nut is tightened
again to prevent unintended turning of the fixing screw.
5. Position drive unit at "glass wing open" and check if the glass
wing squares up with the housing to the passage side.
6. Should the glass wing not square up with the housing repeat
steps 2 to 5 to correct the appropriate difference.
7. Tighten the clamping screws progressively and alternately to a
torque of approx. 15 Nm. Refer to Page 96.
8. Hinge cover strip to carrier pin. Refer to Page 99, Fig. 38.
9. Move carrier to the highest position, so that the carrier pin
abuts upon the edge of the panel.
10. Tighten fastening nuts. Pay attention that the carrier abuts on
the glass wing edge.
1
2
3
4
5
Fig. 36: Changing the cover strip
1 Carrier pin
2 Carrier
3 Cover strip
4 L-lever
5 Fixing screw of the drive unit
11. Fix mounting plate. Refer to Page 94, Fig. 33.
12. Assemble end housing. Refer to Page 92, Fig. 32.
13. Insert plug for the light barriers (ST1  ST4).
14. Insert plug for the Barrier End Display.
Pedestrian Barrier High Door MPH 112
Repair
97