Heated Seats - If Equipped - Jeep GRAND CHEROKEE 2022 Owner's Manual

46 GETTING TO KNOW YOUR VEHICLE
Door Panel Massage Button
Once activated by either method, the massage
controls screen will display on the radio screen,
and "Massage Type" and "Intensity Level" can be
selected for the activated seat.
There are four intensity levels and five massage
types that can be selected.
Intensity Levels:
High

Med

Low

Off

Massage Types:
Waterfall

Lower Back

Extend

Low Extend

Rock Climb

The selected settings will save in the system's
memory when turned off, and will resume the next
time the system is turned on.
NOTE:
The engine must be running for the power seat-

back massage to operate.
The massage feature will turn off after 20 minutes of

use. However, if the massage type or intensity level
is changed, the timer then resets.
H S — I E
EATED EATS F QUIPPED
WARNING!
Persons who are unable to feel pain to the skin

because of advanced age, chronic illness,
diabetes, spinal cord injury, medication, alcohol
use, exhaustion or other physical condition
must exercise care when using the seat heater.
It may cause burns even at low temperatures,
especially if used for long periods of time.
Do not place anything on the seat or seatback

that insulates against heat, such as a blanket
or cushion. This may cause the seat heater to
overheat. Sitting in a seat that has been over-
heated could cause serious burns due to the
increased surface temperature of the seat.
Front Heated Seats
The front heated seats control buttons
are located on the center stack below the
radio screen or within the Uconnect
system. You can gain access to the
control buttons through the Comfort screen.
Press the heated seat switch once to turn the HI

setting on.
Press the heated seat switch a second time to

turn the MED setting on.
Press the heated seat switch a third time to turn

the LO setting on.
Press the heated seat switch a fourth time to

turn the heating elements off.
NOTE:
Once a heat setting is selected, heat will be felt

within two to five minutes.
The engine must be running for the heated

seats to operate.
The level of heat selected will stay on until the

operator changes it.
For information on use with the Remote Start
system, see Ú page 26.