If Engine Fails To Start - Jeep GRAND CHEROKEE 2022 Owner's Manual

122 STARTING AND OPERATING
If the vehicle is not in PARK and the driver turns off
the engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with an 8-speed transmission

Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

NOTE:
For Keyless Enter 'n Go™ equipped vehicles, the
engine will turn off and the ignition switch will
change to the ON/RUN position. After 30 minutes
the ignition switches to OFF automatically, unless
the driver turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits the
vehicle with the engine running, the vehicle may
AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with an 8-speed transmission

Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Driver's seat belt is unbuckled

Driver's door is ajar

Brake pedal is not pressed

The message "AutoPark Engaged Shift to P then
Shift to Gear" will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster. In these cases,
the gear selector must be returned to "P" to select
desired gear.
If the driver shifts into PARK while moving, the
vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed is
1.2 mph (1.9 km/h) or less.
The message "Vehicle Speed is Too High to Shift to
P" will be displayed in the instrument cluster if
vehicle speed is above 1.2 mph (1.9 km/h).
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h), the
transmission will default to NEUTRAL until the
vehicle speed drops below 1.2 mph (1.9 km/h).
A vehicle left in the NEUTRAL position can roll.
As an added precaution, always apply the parking
brake when exiting the vehicle.
4WD LOW — If Equipped
AutoPark will be disabled when operating the
vehicle in 4WD LOW.
The message "AutoPark Disabled" will be
displayed in the instrument cluster.
Additional customer warnings will be given when
both of these conditions are met:
Vehicle is not in PARK

Driver's door is ajar

The message "AutoPark Not Engaged" will be
displayed in the instrument cluster. A warning
chime will continue until you shift the vehicle into
PARK or the driver's door is closed.
ALWAYS DO A VISUAL CHECK that your vehicle is in
PARK by looking for the "P" in the instrument cluster
display and on the gear selector. As an added
precaution, always apply the parking brake when
exiting the vehicle.
I E F T S
F NGINE AILS O TART
If the engine fails to start after you have followed
the "Normal Starting" procedure and has not
experienced an extended park condition (i.e., parked
for more than 30 days), it may be flooded. Push the
accelerator pedal all the way to the floor and hold
it there while the engine is cranking. This should
clear any excess fuel in case the engine is flooded.
The starter motor will engage automatically, run for
10 seconds, and then disengage. Once this occurs,
release the accelerator pedal and brake pedal, wait
10 to 15 seconds, then repeat the "Normal Starting"
procedure.