Chapter 1 • Introduction
• Hydran 201i System Incipient Fault Monitor: Combination of H201Ti's and H201Ci's.
Can be abbreviated as follows:
– Hydran 201i System
• Hydran Host Software: Used for interface between the user and a network of H201Ti's.
Can be abbreviated as follows:
– Hydran Host
1.5
ACCESSORIES
The following accessories are available for the Hydran 201i System. They may be ordered
from General Electric Canada with any of the Hydran 201i System components or
separately.
1.5.1
Hydran 201TW Tube Wrench
The Hydran 201TW Tube Wrench (Figure 1-4 on page 1-8) is required to properly install
the Hydran 201 sensor. One Tube Wrench per site is recommended.
1.5.2
Vibration-Absorbing Rubber Pads
If vibrations are present, these rubber pads (which can be purchased from General Electric
Canada) are used on the back of the Hydran 201Ci Controllers; an example is shown in
Figure 1-5 on page 1-9. Refer to Chapter 3.
1-8
Figure 1-4 - Hydran 201TW Tube Wrench
Rev. 6, March 2011
Part 17997