Assembly - Shop-Vac 610 Series User Manual

TOP HANDLE
If the top handle is not installed on your unit, align holes in handle and holes in motor
cover and secure with screws provided.
CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
metal taNk wItH plaStIC dolly aNd Four CaSterS
You will find four casters with your wet/dry vacuum. Assemble as follows:
1. With the cord disconnected from the receptacle and tank cover removed, turn tank upside down so that
bottom is facing up.
2. Insert casters into bottom of dolly by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place.
3. Return tank to upright position.
metal taNk wItH plaStIC dolly aNd rear wHeelS
You will find two casters, two large rear wheels, one axle, tool rack and two cap nuts. If your vacuum is 16
U.S. gallons (60.5 liters) or larger you will also find two screws, two metal flat washers and two square nuts
with your wet/dry vacuum. Assemble as follows:
1. Make sure the cord is disconnected from the receptacle then remove the tank cover.
2. If your unit is 4 U.S. gallon (15.1 liter) to 14 U.S. gallon (53 liter), assemble as follows:
a. Turn tank upside down so the bottom is facing up.
b. Continue on to step 4 below.
3. If your unit is 16 U.S. gallon (60.5 liter) or above, assemble as follows:
a. With the tank upright and back facing you, insert square nut into one of the two
slots located in back of dolly.
b. Place metal flat washer over stem of screw.
c. Tilt the tank forward slightly and locate the hole provided in the underside of the
dolly directly below the slot containing the square nut.
d. Place the screw, containing the flat washer, into the hole and turn clockwise until
end of screw is connected to square nut. If you have difficulty getting the screw to
connect to the square nut, push downward on the square nut with the eraser end
of a pencil while turning the screw.
e. Finish tightening the screw using 7/16" socket, wrench or nut driver.
f. Repeat steps a to e with the second slot in dolly.
g. Turn tank upside down so bottom is facing up. Continue on to step 4 below.
4. Place axle upright on a hard surface and hammer on one cap nut.

ASSEMBLY

PAGE 5