Assembly - Shop-Vac SM12 Series User Manual

CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
PLASTIC TANK WITH CASTER FEET
You will ind four caster feet, four casters and four screws with your vacuum. Assemble as
follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down
so that bottom is facing up.
2. With front of tank facing you, take caster feet marked with the
letter A and place in slots on left front and right rear of tank also marked with the
letter A. Secure with screws provided.
3. Take caster feet marked with the letter B and place in slots on right front and
left rear of tank also marked with the letter B. Secure with screws provided.
4. If lat washers are included in hardware package place lat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
5. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
METAL TANK WITH CASTER DOLLY
You will ind four casters, two screws and a tool rack with your vacuum. Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down
so that bottom is facing up.
2. Install tool rack onto dolly (already installed on tank) by placing
large slot in tool rack over rim on back of dolly. Push tool rack onto
dolly until it is lush with the bottom of the dolly. Secure with screws
provided.
3. Insert casters into bottom of dolly by placing stem of caster
into holes provided. Apply pressure and twisting motion until
casters snap into place. Return tank to upright position.
PLASTIC TANK WITH REAR CASTER DOLLY
You will ind four casters, two caster feet, one dolly and four screws with your wet/dry vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that the bottom is facing up.
2. Take rear caster dolly and place into slots (on rear of tank, opposite of
inlet) and secure with screws provided.
3. If lat washers are included in hardware package place lat washer over
stem of caster before installing casters into feet and dolly. NOTE: Flat
washers are not required with all units.

ASSEMBLY

Screw
Caster
Foot
Screw
Caster
Caster
Foot
Caster
PAGE 5
Caster
Foot