Unpacking; Assembly - Shop-Vac SE16-SQ550 Owner's Manual

UNPACKING

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.

ASSEMBLY

CASTER SYSTEM
ASSEMBLY
You will find four casters FIGURE
1, accessory caddy FIGURE 2,
two caster feet FIGURE 3, four
screws and four washers with your
wet/dry vacuum. Assemble as
follows:
FIGURE 1
FIGURE 2 FIGURE 3
1. With cord disconnected from the receptacle and tank
cover removed, turn tank upside-down so bottom is
facing up.
2. Take accessory caddy and place
into slots located on rear of tank
(opposite of drain). Secure with
screws provided.
FIGURE 4.
FIGURE 4
3. Take two casters and place a flat
washer over the stem of each caster.
Install casters into accessory caddy
by inserting the caster stems into
the holes provided. Apply pressure
and twisting motion until the casters
snap into place. FIGURE 5.
FIGURE 5
4. With tank drain facing you, take
caster foot marked with the letter
A and place into slot on left side of
tank, also marked with the letter A.
FIGURE 6.
A
FIGURE 6
A
FIGURE 7
A
B
FIGURE 8
B
FIGURE 9
FIGURE 10
9. Return tank to upright position.
HOSE HOLDER
INSTALLATION
If not already installed, assemble as follows:
FIGURE 11
FIGURE 12
FIGURE 13
5. Secure caster foot to tank with
screw provided. FIGURE 7.
6. Take caster foot marked with the
letter B and place into slot on right
side of tank, also marked with the
letter B. FIGURE 8.
7. Secure caster foot to tank with
screw provided. FIGURE 9.
8. Take the remaining casters and
place a flat washer over the stem
of each caster. Insert casters into
caster feet by placing the caster
stems into the holes provided. Apply
pressure and twisting motion until
casters snap into place.
FIGURE 10.
10. With rear of unit facing you, take
hose holder and position it with tabs
facing rear of unit.
FIGURE 11.
11. Place "J" shaped tabs into the
slots on cord wraps. FIGURE 12.
Press down until tabs snap into
place.
12. Press down on center of hose
holder until tab latches on bottom of
tank cover. FIGURE 13.
PAGE 5