Unpacking; Assembly - Shop-Vac SL14-450 Abridged User Manual

UNPACKING

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.

ASSEMBLY

CASTER SYSTEM
ASSEMBLY
FIGURE 1
FIGURE 2
Assemble as follows:
2. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that the
bottom is facing up.
A
A
A
A
FIGURE 3
B
FIGURE 4
1. You will find four caster
feet FIGURE 1, four casters
FIGURE 2, and four screws
with your wet/dry vacuum.
3. With tank drain facing you,
take caster feet marked with
letter A and place in slots on
left front and right rear of tank
also marked with the letter A.
FIGURE 3.
4. Secure with screws provided.
FIGURE 4.
B
A
B
B
A
B
FIGURE 5
FIGURE 6
FIGURE 7
8. Return tank to upright position.
TOOL HOLDER
ASSEMBLY
FIGURE 8
FIGURE 9
FIGURE 10
5. Take caster feet marked
with the letter B and place on
right front and left rear of tank
also marked with the letter B.
FIGURE 5.
6. Secure with screws provided
FIGURE 6.
7. Insert casters into feet by
placing stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place. FIGURE 7.
9. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 8.
10. Place "J" shaped tabs
into the slots on cord wraps
FIGURE 9. Press down until
tabs snap into place.
11. Press down on center of
tool holder until tab latches on
bottom of lid. FIGURE 10.
PAGE 5