Assembly - Shop-Vac SC16 Series User Manual

CASTER SYSTEM
You will ind four caster feet, four casters and four screws with your vacuum. Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down
so that bottom is facing up.
2. With front of tank facing you, take caster feet marked with the letter A and
place in slots on left front and right rear of tank also marked with the letter
A. Secure with screws provided.
3. Take caster feet marked with the letter B and place in slots on right front
and left rear of tank also marked with the letter B. Secure with screws
provided.
4. If lat washers are included in hardware package place lat washer over
stem of caster before installing casters into feet. NOTE: Flat washers are
not required with all units.
5. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
HOSE HOLDER INSTALLATION
(Not standard wi th al l model s)
If not already installed, assemble as follows:
1. With rear of unit facing you, take hose holder and position it with tabs facing rear of
unit.
2. Place "J" shaped tabs into the slots on cord wraps. Press down until tabs snap into
place.
3. Press down on center of hose holder until tab latches on bottom of tank cover.
AIRFLOW INDICATOR ASSEMBLY (PERFORMANCE GAUGE)
If your unit came with an airlow indicator, assemble as follows:
1. Set tank cover onto the tank. Position with back of tank cover facing you.
2. Take ilter indicator and position with side, containing the wording, facing down.
3. Locate the slot, below the blower port, on the back of the tank cover. Push the lat end of the indicator
into the slot. Give a slight tug on the end of the indicator to make sure it is secure.

ASSEMBLY

Screw
Caster
Foot
Screw
Caster
Caster
Foot
PAGE 5
Caster
Foot