Error - Cause - Remedy; Pop-Up Message - vacuubrand VAC 24seven Instructions For Use Manual

Troubleshooting
Error – Cause –
Remedy
54
6.2 Error – Cause – Remedy 6.2 Error – Cause – Remedy
6.2.1 6.2.1

Pop-up message

Pop-up message
Error Error ` Possible cause
Communication ` One or more
error VACUU·BUS components
were removed.
Frequency con‑ ` Address incorrectly con‑
verter (FC) error figured.
` Temperature too high.
FC defective.
`
Error ` Valve defective.
affecting control
Error at pump ` Check VMS‑B (switching
device).
Error at digital I/O ` No power supply at IN of
module I/O module.
Plug pulled out.
`
` An error occurred in the
system and the I/O mod‑
ule relayed it to the con‑
troller.
Error at analog I/O No power supply.
`
module
Error Ambient temperature too
`
affecting Peltronic high, device overheating.
` Very high condensing
capacity.
Device defective.
`
Error at vacuum Vacuum sensor defective.
`
sensor
Overpressure ` Pressure too high.
` Measuring range
exceeded.
Underrange ` Pressure below measur‑
ing range.
` Vacuum sensor calibra‑
tion incorrect.
 Remedy
Deactivate relevant

VACUU·BUS compo‑
nents.
Perform component

recognition.
Configure correct

address.
Replace defective com‑

ponents.
Check address.

Replace defective com‑

ponents.
Send in defective

device.
Connect power supply.

Check plug‑in connec‑

tion.
Remedy cause of exter‑

nal error.
Connect power supply.

Eliminate reason for

Peltronic overheating.
Send in defective

device for repair.
Replace defective

device.
Send in defective com‑

ponent.
Acknowledge warning.

Eliminate cause of

overpressure.
Calibrate vacuum sen‑

sor correctly.
20901531_EN_VACUU·SELECT_V1.0_010621
Personnel
Specialist
Resp. spe-
cialist
Specialist
Resp. spe-
cialist
Specialist,
resp. spe-
cialist
Specialist
Specialist
Resp. spe-
cialist
Operator,
specialist
Specialist