vacuubrand VAC 24seven Instructions For Use Manual page 41

 Example
Overview of
context menus Settings
Overview of possible
basic settings
20901531_EN_VACUU·SELECT_V1.0_010621
Description of basic settings
Function
Autostart*
Vacuum sensor
Use venting valve when
target value changes
Coolant valve(s) run‑on
time**
Level sensor(s) delay
time**
** Option: Shown if component is connected and recognized.
The Basic Settings context menu adapts to the connected VACUU·BUS
nents, e.g., a level sensor is connected and activated via component recognition >
entry for delay time is listed in the context menu.
You can specify presettings for your pro‑
cess in Basic Settings:
Setting Description
Off / On Off: The controller remains on Stop when
the power supply is switched on.
On: A started application is continued
after the power supply has dropped off
(switch off or failure) and is subsequently
switched on again. Recommended, for
example, when an external switch in the
lab furniture is to be used to start up a
previously running controller.
VS‑C _ / VS‑P _ Vacuum sensor selection for the con‑
troller, provided more than one is con‑
nected. VS‑C _: rough vacuum; VS‑P _:
Fine vacuum
Off / On Off: Venting valve does not respond
when target value changes.
On: Venting valve responds if required
for target value adjustment.
Off / hh:mm:ss Specified time for coolant run-on time.
Off / hh:mm:ss Delay time for switching off after full sta‑
tus indication
Main menu
VACUU·BUS compo‑
41