Creating A Configuration; Creating New Project Settings - Siemens SIMATIC Ident RF1000 Configuration Manual

Creating and transferring a configuration

5.1 Creating a configuration

The following options are available to prepare the configuration for use:
• Transfer the finalized configuration file to the reader using a computer and the Config
editor.
• Alternatively, you can create a configuration card on which you save the finalized
configuration file. Using the configuration card and the demo application
("RF1000R.exe"/"AccessControlDemo.exe"), you can then transfer the configuration to
permanently installed readers.
5.1 Creating a configuration
5.1.1

Creating new project settings

The creation of a new project setting ("Extend Configuration > Add...") is described below.
Requirements
• The Config editor has been installed on your computer.
• An RF1000 reader that you can connect to your computer.
• A transponder or an access card.
Creating a project setting
Follow these steps to create a new project setting:
1. Open the Config editor by double-clicking the "config_editor.exe" file.
2. In the popup window, click the "New" button.
Response: The "Administrative Information" page opens.
3. Enter the administrative information of your project.
This information will facilitate you in the identification, assignment and management of
your projects.
– Enter a name for your project.
– Do not select the check box "Follow Baltech Naming Convention".
– Add a description of the project.
16
For example, the name of the building or the department in which the reader is to be
installed.
For example, a brief summary of the intended behavior of the reader.
Configuration Manual, 07/2021, C79000-G8976-C647-01
SIMATIC RF1000