Robotware 6 Compatibility; General Compatibility Limitations - ABB RobotStudio 2022.1 Release Notes

RobotWare 6 Compatibility

Overview
RobotWare 6.00 and 6.00.01 systems cannot be directly upgraded to RobotWare 6.01. To upgrade a
system, you need to create backup and migrate it using the tool 'Migrate Backup or Folder', then
recreate the system and finally, restore the backup. For this reason, the functions 'Unpack&Work', 'Go
Offline' and 'New Solution with Station and Robot Controller – From backup' are blocked to prevent
upgrade from RobotWare 6.00 or 6.00.01 to RobotWare 6.01. RobotStudio, however, is compatible with
both RobotWare 6.00 / 6.00.01 and 6.01.

General Compatibility Limitations

Safety Configuration
Safety configuration of a track motion IRC5 system equipped with a safety controller of type EPS or
SafeMove can be done without the need to read track motion parameters manually when using
RobotWare 5.11.01 or later. Encrypted parameters needed by the safety controller will be automatically
read by EPS Wizard and SafeMove Configurator, respectively.
Configurations
The feature Configurations for selecting the robot arm configuration (confdata) may fail, or not present
all solutions, in some specific circumstances even when the target is reachable if RobotWare 5.14 or
earlier is used.
Workaround: Upgrade to RW5.14.01 or later
© Copyright 2021 ABB. All rights reserved. 30/30