Table of Contents
Advertisement
RobotWare Compatibility
Supported RobotWare versions
RobotStudio works with RobotWare 5.07 and later. Please check details below. The latest supported
RobotWare version for IRC5 and OmniCore controllers is stated under Help/About in RobotStudio.
RobotWare packages can be added to RobotStudio from the RobotApps window.
RobotWare 5.05 and 5.06 Compatibility
RobotWare 5.05 and 5.06 including revisions thereof are not supported by RobotStudio 5.15 and later
versions. Please use the corresponding version of RobotStudio for managing robot controllers with any
of these RobotWare versions.
RobotWare 5.07 Compatibility
General
The location of the program pointer is not updated in the RAPID Editor during program execution.
Offline
A limitation in the versions 5.07.02, 5.07.03, and, 5.07.04 of RobotWare may cause the Virtual Controller
to System Failure state during I-start on certain computers. The problem is due to the ctrl.bin-file not
being correctly created.
Workaround: Create an empty ctrl.bin file in the INTERNAL folder of the controller system, and then
perform a warm start.
Note: The problem will reappear if the system is I-started. The virtual controller does not support
RobotWare 5.07.08 and RobotWare 5.07.07.
Online
FlexPendant Viewer does not work RobotWare 5.07.
RobotWare 5.08 Compatibility
RobotWare 5.08 and its revisions of are supported with the following limitations:
Offline
RobotWare 5.08 is not supported.
Workaround: Use RobotWare 5.08.01 or later.
RobotWare 5.10 Compatibility
RobotWare 5.10 and its revisions of are supported with the following limitations:
Offline
Starting a controller will generate internal UAS error in controller error log.
RobotWare 5.11 Compatibility
RobotWare 5.11 and its revisions of are supported with the following limitations:
Offline
Linear jogging of a robot across joint values that will cause a change of confdata may fail. For example,
if the robot is jogged linearly when joint values is passing 90 degrees for axis 1 may cause the robot to
stop or to change configuration.
© Copyright 2021 ABB. All rights reserved.
28/30
Advertisement
Table of Contents
