Intex Krystal Clear Deluxe Owner's Manual page 21

(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5" X 10.5" PANTONE 295U
After the salt is dissolved, but before starting the sanitizer generation be sure
that:
• The system is connected to a grounding type receptacle protected by a
ground-fault circuit interrupter (GFCI).
• The filter pump operates several minutes before starting the saltwater system
(This removes air pockets and debris in the water hoses).
• No air is trapped in any of the hoses. Follow "Filter Pump Operation" above to
release any trapped air.
1. With the Filter Pump turned "ON" and operating. Code "88"
appears on the electronic control station's LED indicating the
unit is in a Stand-By Mode, this is normal.
2. Unlock keypad controls:
Press and hold
"beep", then press and hold
until you hear the second short "beep", LED flashes "00". This
procedure unlocks the keypad control buttons.
3. Set saltwater system operating hours:
Increase the scheduled number of hours of
operation by pressing
by pressing
Table" for pool size and required operating
hours. Press
required, press
selected. The built-in timer will now operate
for the number of hours selected at the
same time each day.
NOTE: The saltwater system will not operate if the filter pump is not operating.
4. Re-lock keypad controls:
With the proper hour value showing, press and hold
for 2 seconds until you hear a long "beep", then press and hold
long "beep". A green LED light on the control panel will light up
within a few minutes, which indicates the saltwater system
starting sanitizer production. Filter pump can be run alone
without the saltwater system, with the proper hour value
showing, press and hold both
long "beep". By locking the control buttons into this setting you will prevent
unauthorized changing of the operating cycle.
NOTE: If you forget to Re-lock the keypad controls, the salt system will
automatically lock the keypad controls and start working 1 minute later.
SAVE THESE INSTRUCTIONS
SALTWATER SYSTEM OPERATION
button for 2 seconds until you hear a short
button, or reduce
button. See "Operating Time
button to select hours
if too many hours were
button for another 2 seconds until you hear the second
button for another 2 seconds
(1 to 12 hours max per cycle)
button
and buttons for 2 seconds until you hear a
12/25/2007
103
CD
Page 21