Intex Krystal Clear Deluxe Owner's Manual page 26

(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5" X 10.5" PANTONE 295U
1. Switch off the unit, unplug the power cord from the electrical socket.
2. Grasp a plunger valve handle. Turn the handle counter-clockwise, push down
until it stops and then turn it clockwise until the plastic protruding notch anchor
is in the "0/I" position. Repeat for the 2nd plunger valve. This prevents the water
from flowing out of the pool.
3. Disconnect the water return (to the pool) hose from the saltwater system outlet.
Disconnect angle joint (17) from the filter housing and flow sensor conduit (15).
4. Look inside the electrolytic cell (13) inspect for scale formation (light colored
crusty or flaky deposits) on the titanium plates. If no deposits and debris are
visible reinstall the cell and hose.
5. If deposits and debris are seen on the titanium plates, use a high pressure
garden hose and try to flush them off. Only flush from the direction of water
inlet to avoid damaging the flow sensor. Do not use any metal tool as this will
scratch the coating off the plates. Note that a buildup on the cell indicates that
there is an unusually high calcium level in the pool. If this is not corrected, you
have to frequently check and clean the cell. To avoid this, always keep your pool
chemistry at the recommended levels. See "Pool Maintenance & Chemical
Definitions" for reference.
SAVE THESE INSTRUCTIONS
VISUAL INSPECTION AND CLEANING
15
17
Titanium Plates
12/25/2007
103
CD
Page 26