Intex Krystal Clear Deluxe Owner's Manual page 32

(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5" X 10.5" PANTONE 295U
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
CODE 90
CODE 91
CODE 92
SAVE THESE INSTRUCTIONS
TROUBLESHOOTING GUIDE (continued)
PROBLEM
1. Circulation line is blocked.
2. Incorrect inlet and outlet hose
direction.
3. Scale on the flow sensor.
4. Flow sensor cord is loose.
5. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / no salt.
3. Possible electrolytic cell failure.
1. High salt level.
REMEDY
• Ensure the plunger valves are opened
(if any).
• Ensure your filter cartridge and cell are
clear from debris and dirt. See
"Maintenance".
• Release all trapped air in the circulation
line. See Filter Pump Manual.
• Check for the direction of water inlet
and water outlet hose. Reverse the
hoses if necessary. See "Set Up
Instructions".
• Ensure the flow sensor (especially the
hinge) is clean. See "Maintenance".
• Check for flow sensor loose or not
connected properly. Plug the flow
sensor firmly into the flow sensor
receptacle.
• Contact Intex Service Center for
replacement.
• Remove the electrolytic cell for
inspection and clean it if necessary.
See "Maintenance".
• Add salt. See "Salt & Pool Water
Volumes".
• Contact Intex Service Center. Replace
the cell if needed.
• Partially drain the pool and refill with
fresh water. See "Salt & Pool Water
Volumes".
12/25/2007
103
CD
Page 32