Hour Meter (Digital Type); Trip Meter; Clock - Yamaha F50 Owner's Manual

Basic components
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
EMU26650

Hour meter (digital type)

This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
Changing the display format
G
Pressing the "
G
es the display format in the following pat-
tern:
Total hours→Trip hours→Display off
G
Resetting the trip hours
G
Simultaneously pressing the "
G
and " " (mode) buttons for more than
1 second while the trip hours are displayed
32
ZMU01740
ZMU01741
" (mode) button chang-
" (set)
resets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26690

Trip meter

This gauge displays the distance the boat
has traveled since the gauge was last reset.
Press the " " (mode) button repeatedly
until the indicator on the face of the gauge
points to " " (trip). To reset the trip meter
to zero, press the "
(mode) buttons at the same time.
NOTE:
The trip distance is shown in kilometers or
G
miles depending upon the unit of measure-
ment selected for the speedometer.
The trip distance is kept in memory by bat-
G
tery power. The stored data will be lost if
the battery is disconnected.
EMU26700

Clock

Press the " " (mode) button repeatedly
until the indicator on the face of the gauge
points to " " (time). To set the clock, be
sure the gauge is in the "
Press the " " (set) button; the hour display
will begin blinking. Press the "
button until the desired hour is displayed.
Press the " " (set) button again, the minute
" (set) and "
" (time) mode.
" (mode)
"