Trim Tab With Anode; Tilt Support Lever For Power Trim And Tilt Model - Yamaha F50 Owner's Manual

1. Variable trolling RPM switch
EMU26243

Trim tab with anode

The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side "A"
in the figure. If the boat tends to veer to the
right (starboard side), turn the trim tab end to
the starboard side "B" in the figure.
ECM00840
CAUTION:
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it
will become ineffective as an anode.
Basic components
1
1. Trim tab
2. Bolt
3. Cap
A
1
2
1. Trim tab
2. Bolt
Bolt tightening torque:
36.0 Nm (26 ft-lb) (3.6 kgf-m)
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
3
2
B
A
ZMU02525
B
ZMU03097
27