Yamaha F50 Owner's Manual page 83

stand. You could be severely injured if
the outboard motor falls on you.
Never get under the lower unit while it
G
is tilted, even when the tilt support lever
or knob is locked. Severe injury could
occur if the outboard motor accidental-
ly falls.
1. Tilt the outboard motor so that the gear
oil drain screw is at the lowest point pos-
sible.
2. Place a suitable container under the
gear case.
3. Remove the gear oil drain screw and
gasket.
1. Gear oil drain screw
2. Oil level plug
NOTE:
If a magnetic gear oil drain screw is
G
equipped, remove all metal particles from
the screw before installing it.
Always use new gaskets. Do not reuse the
G
removed gaskets.
4. Remove the oil level plug and gasket to
allow the oil to drain completely.
ECM00710
CAUTION:
Inspect the used oil after it has been
drained. If the oil is milky, water is getting
into the gear case which can cause gear
damage. Consult a Yamaha dealer for re-
pair of the lower unit seals.
NOTE:
For disposal of used oil, consult your
Yamaha dealer.
5.
2
1
ZMU03273
6.
7.
Maintenance
With the outboard motor in a vertical po-
sition, and using a flexible or pressur-
ized filling device, inject the gear oil into
the gear oil drain screw hole.
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
F50TR 430.0 cm
(15.17 Imp.oz)
F60CTR 430.0 cm
(15.17 Imp.oz)
T50TR 670.0 cm
(23.63 Imp.oz)
T60TR 670.0 cm
(23.63 Imp.oz)
Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
3
(14.54 US oz)
3
(14.54 US oz)
3
(22.65 US oz)
3
(22.65 US oz)
ZMU03274
77