Cleaning The Outboard Motor; Checking Painted Surface Of Motor - Yamaha F50 Owner's Manual

the garden hose connector from the fit-
ting on the bottom cowling.
3
1. Fitting
2. Garden hose adapter
3. Garden hose connector
2. Screw the garden hose adapter onto a
garden hose, which is connected to a
fresh water supply, and then connect it
to the garden hose connector.
3. With the engine off, turn on the water tap
and let the water flush through the cool-
ing passages for about 15 minutes. Turn
off the water and disconnect the garden
hose adapter from the garden hose con-
nector.
4. Reinstall the garden hose connector
onto the fitting on the bottom cowling.
Tighten the connector securely.
ECM00540
CAUTION:
Do not leave the garden hose connector
1
2
ZMU05096
loose on the bottom cowling fitting or let
the hose hang free during normal opera-
tion. Water will leak out of the connector
instead of cooling the engine, which can
cause serious overheating. Be sure the
connector is tightened securely on the fit-
ting after flushing the engine.
NOTE:
When flushing the engine with the boat in
G
the water, tilting up the outboard motor un-
til it is completely out of the water will
achieve better results.
For cooling system flushing instructions,
G
see page 61.
EMU28450

Cleaning the outboard motor

After use, wash the exterior of the outboard
motor with fresh water. Flush the cooling
system with fresh water.
NOTE:
For cooling system flushing instructions, see
page 61.
EMU28460

Checking painted surface of motor

Check the motor for scratches, nicks, or flak-
ing paint. Areas with damaged paint are
more likely to corrode. If necessary, clean
and paint the areas. A touch-up paint is avail-
able from your Yamaha dealer.
Maintenance
ZMU02550
65