Casio Celviano 6ES1A User Manual page 33

■ To edit the chord progression
1.
On the editing operation selection screen
(page E-27), select "CHORD" and then press
the  (ENTER) button to display the chord
progression editing screen shown below.
(1) Step (timing and chord)
(2) Cursor
(1) Step (timing and chord)
The timing of a chord progression is expressed as a
series of three values separated by colons (such as
001:1:00) indicating measure
*2
tick (00). This series of three values is referred to
collectively as a "step".
The screen shot above shows the first two steps
(001, 002) of the Music Preset. Use the
 (FF) buttons to scroll and view other steps.
*1 Up to 999 measures
*2 There are 12 ticks per beat, as shown below.
Chord progression
Measure 1
Beat 1 Beat 2 Beat 3
Tick
00 01 02
001:1:00
(2) Cursor
Specifies the step that is currently selected for
editing.
(3) Resolution
Resolution is a unit used when editing step timing.
The initial resolution is R1 (one measure), but you
also can select R4 (1 beat = 4 quarter notes) when
you want to specify chords for each beat. Use the
instrument part buttons (
one of the eight resolutions shown below.
ck cl cm
R1 R2 R4
(1 measure) (2 beats) (1 beat) (1/2 beat)
(3) Resolution
*1
(001), beat (1), and
 (REW) and
Measure 2
Beat 4 Beat 1 Beat 2
002:1:00
09 10 11
For the sample display
above, the chord change
from C to Bm occurs here.
 through  ) to select
cn co cp cq cr
R8 R8T R16 R16T R32T
3 3 3
(1/3 beat) (1/4 beat) (1/6 beat) (1/12 beat)
2.
Use the  (REW) and
move the cursor (2) on the chord progression
editing screen to the step you want to select.
3.
Change the content of the selected step as
desired.
3-1. Select a chord fingering mode and use the
chord keyboard (page E-18) to input chords.
Fingering a chord causes the cursor (2) to
move to the next step automatically.
• If you want to advance to the next step
without changing the current chord, press
the  (PAUSE) button.
• If (3) Resolution is shorter than the time up
to the next step, a new step (without chord)
that is equal to the time of the resolution
will be inserted temporarily into the Music
Preset. Fingering a chord for the new step
will cause the step to be registered as part
of the Music Preset, and the cursor will
advance to the next step.* You can use this
operation to insert a new step between the
current and following step.
* Using the

(REW) and
move the cursor without inputting a chord
will delete the temporarily inserted step.
(w, q) buttons to change the
3-2. Use the 
step timing (measure:beat:tick).
Each press of either button changing the
timing in accordance with the resolution.
• The range of values you can specify for the
step timing is limited by the steps before
and after the current step.
• The timing of the first step (001:1:00) is
fixed and cannot be changed. Also, the final
step is always one measure, regardless of
the resolution.
Last step
3-3. To delete a step, press both of the
q) buttons at the same time.
• You cannot delete the first step or the last
step.
Music Presets
 (FF) buttons to

(FF) buttons to
 (w and
E-29